C&S Connect
ASME Proposals Available For Public Review
Project Initiation Notification System (PINS)

ASME is required to provide notification of the initiation and scope of activities expected to result in new or revised American National Standards. The following listing is provided for this purpose. Directly and materially affected interest wishing to receive more information should contact the staff person indicated. Any comments regarding the listed notifications should be submitted to the staff contact indicated prior to the comment deadline date shown.

For inquiries please contact:
Sort the Search Results by clicking on an underlined column header.
Title: Staff Contact: Comment Deadline:

Revise current ANS: ASME B18.2.2 - 20XX, Nuts for General Applications: Machine Screw Nuts, Hex, Square, Hex Flange, and Coupling Nuts (Inch Series)

Angel L. Guzman Rodriguez 10/30/20
This Standard is intended to cover the complete general and dimensional data for the various types of inch series square and hex nuts, including machine screw nuts and coupling nuts, addressed by this Standard.

Create a new American National Standard (ANS): ASME PHM-01 - 20XX, Guideline for When and Where PHM should be Integrated in Manufacturing Operations

Donnie Alonzo 10/26/20
The proposed guidelines will include recommended best practices to
(a) identify areas where operational efficiencies can be improved
(b) define use cases linked to desired safety, environmental, and cost?benefit factors as well as operational improvements
(c) establish a baseline of current maintenance practices and health?ready capability levels
(d) implement cost?effective equipment asset condition management (ACM2) strategies and measure their effectiveness in improving operational efficiencies

Revise current ANS: ASME Y14.43 - 20XX, Dimensioning and Tolerancing Principles for Gages and Fixtures

Fred Constantino 10/24/20
This Standard presents the design practices for dimensioning and tolerancing of gages and fixtures used for the verification of maximum material condition (MMC) size envelopes and virtual condition boundaries generated by geometric tolerances controlled at maximum material condition. Examples of gages used to inspect workpieces using regardless of feature size (RFS) are covered in an Appendix.

Revise, redesignate and consolidate current ANS: ASME Y14.39 - 20XX, Preferred Limits and Fits

Fred Constantino 10/31/20
This standard describes the limits and fits for mating parts. It defines terminology, symbols, preferred base sizes (first and second choices), and preferred tolerances (first, second and third choices). Tolerances for base sizes from 500 mm to 3150 mm are specified. Preferred limits and fits for sizes (first choice only) up to and including 20 in. and 500 mm are also included.

Create a new American National Standard (ANS): ASME HR-1 - 20XX, Power Generating Facilities: Continuous Power Output and Heat Rate

Michelle Pagano 11/08/20
This document will provide rules and methods for the determination of continuous power output and heat rate with the lowest achievable uncertainties for hydrocarbon fueled Rankine cycle power generating facilities. Implementation of a continuous performance monitoring program will be outlined.

Minimum Site Requirements: IE 6.0+Firefox 2.0+Chrome 4.0+

Copyright © 1996-2016 ASME. All Rights Reserved. Terms of Use | Privacy Statement