C&S Connect
 
ASME Proposals Available For Public Review
Project Initiation Notification System (PINS)

ASME is required to provide notification of the initiation and scope of activities expected to result in new or revised American National Standards. The following listing is provided for this purpose. Directly and materially affected interest wishing to receive more information should contact the staff person indicated. Any comments regarding the listed notifications should be submitted to the staff contact indicated prior to the comment deadline date shown.


For inquiries please contact:
Sort the Search Results by clicking on an underlined column header.
Title: Staff Contact: Comment Deadline:

Revise current ANS: ASME B16.39 - 20XX, Malleable Iron Threaded Pipe Unions

Ray Rahaman 09/27/19
This Standard covers threaded malleable iron unions,
Classes 150, 250, and 300. It also contains provisions for using steel for NPS 1/8 unions.


Create a new American National Standard (ANS): ASME B40.300 - 20XX, Digital Instruments

Angel L. Guzman Rodriguez 10/28/19
This standard will cover digital thermometers for industrial, process, commercial, and laboratory and test equipment.


Revise and Partition current ANS: ASME MFC-3.1 - 20XX, Measurement of Fluid Flow in Pipes using Orifice, Flow Nozzle, and Venturi – Part 1: General

Michelle Pagano 09/29/19
The purpose of this Standard is to provide general material such as definitions, symbols, measurement principles, measurement and installation requirements, as well as uncertainty calculations that apply to orifice, nozzle and venturi devices for which the flow remains subsonic throughout the measuring section and where the fluid is considered as single-phase.


Revise, redesignate and consolidate current ANS: ASME MFC-3.2 - 20XX, Measurement of Fluid Flow in Pipes using Orifice, Flow Nozzle, and Venturi – Part 2: Orifice Meters

Michelle Pagano 09/29/19
The purpose of this Standard is to specify the geometry and method of use (installation and operating conditions) of orifice meters when they are inserted in a conduit running full to determine the flow rate of the fluid flowing in the conduit.


Revise and Partition current ANS: ASME MFC-3.3 - 20XX, Measurement of Fluid Flow in Pipes using Orifice, Flow Nozzle, and Venturi – Part 3: Flow Nozzles and Venturi Nozzles

Michelle Pagano 09/29/19
The purpose of this Standard is to specify the geometry and method of use (installation and operating conditions) of flow nozzles and venturi nozzles when they are inserted in a conduit running full to determine the flow rate of the fluid flowing in the conduit.


Revise and Partition current ANS: ASME MFC-3.4 - 20XX, Measurement of Fluid Flow in Pipes using Orifice, Flow Nozzle, and Venturi – Part 4: Venturi Meters

Michelle Pagano 09/29/19
This Standard specifies the geometry and method of use (installation and operating conditions) of venturi meters when they are inserted in a conduit running full to determine the flow rate of the fluid flowing in the conduit.



Minimum Site Requirements: IE 6.0+Firefox 2.0+Chrome 4.0+

Copyright © 1996-2016 ASME. All Rights Reserved. Terms of Use | Privacy Statement